7/6/2023 0 Comments Dmesh wreathI’d recommend cutting the pieces of regular ribbon about 1 1/2 – 3″ inches longer than the height of your mesh, depending on how much you want to poke out. I cut mine the same height and it ended up not sticking out enough to be very noticeable in the wreath unless you’re close to it. When cutting your regular ribbon, cut it a bit longer than the height of your mesh ribbon. The pieces of cut mesh ribbon were about 7″ most of the time. Once it creates a full circle, cut the piece of mesh. To eyeball the length needed, you just need to begin to roll the mesh. I started by measuring 8″ pieces, but quickly switched to an eyeballing technique. You can either measure the mesh or you can eye ball it. They were perfect for my wreath! Cut pieces of mesh ribbon and regular ribbonįirst, cut pieces of ribbon, a lot of them! A 14″ Easter mesh wreath requires approximately 70 pieces of mesh ribbon, along with pieces of regular ribbon. I can’t believe these cute picks were only $1. The image below shows my key project supplies.
0 Comments
Leave a Reply. |